Filter
Top Products
MS860 WiFi Manual
NETWORK SETTINGS
Save the configuration settings
Example: SAVE CR
13. SAVE
Save the configuration settings and reboot
Example: SE CR
14. SE
Restore configuration settings to factory default, and automati-
cally reboot the module
Example: DEFAULT CR
15. DEFAULT
Reboot the module without saving any configuration changes
Example: EXIT CR
16. EXIT
Once you have completed the network configuration for the
scanner, VCOM will be required to configure the virtual com port,
which means the VCOM utility must run in the background. This
is detailed on pages 21 to 24.
Some Access Points may not be able to re-connect the MS860
and its cradle after it’s been out of range. In this case the scan-
ner will need to be powered off and powered on again, and the
VCOM communication must be re-started.
VCOM Utility supports Windows2000 and XP.
Unfortunately, Windows98 and NT are not currently supported.
Before entering into Command Mode, power off the scanner and
then scan “Enter Group 10” on page 81 within 5 seconds after
powering the scanner back on.
IMPORTANT:
20