Filter
Top Products
MS860 WiFi Manual
INTRODUCTION
Continuous High-Low Beeps
If scans are attempted out of range, communication will be broken.
The scanner LED will remain red and you will hear a continuous high-
low beep from the scanner when you scan bar codes.
If the Access Point is powered off, this means the communication
between the scanner and the Access Point is lost. You will also hear a
continuous high-low beep from the scanner when you scan bar codes.
Buzzer
The MS860 provides audible feedback while it is in operation. These
sounds indicate the operating status of the scanner.
One High Tone Beep
The scanner will beep once after successfully reading a bar code.
One High-Low-High Beep
After scanning a ‘begin configuration’ bar code (“Enter Group 5”, for
instance), the scanner LED will flash green while the scanner simulta-
neously gives one high-low-high tone beep. Upon exiting configuration
mode by scanning an “Exit” bar code, the scanner will give one high
tone beep, and the scanner LED will stop flashing.
6