Filter
Top Products
MS860 WiFi Manual
SCANNER CONFIGURATION MANAGER
Scanner Port, continued
Code 11 / Telpen
Codabar
UPC-A
UPC-E
EAN-13
EAN-8
I 2 of 5
S 2 of 5
Code 39
Code 93
Code 128
UCC / EAN 128
MSI
Code 32
Plessey Code
Label Code IV or V
Toshiba Code
Delta Code
A
]C1
J
T
M
N
K
D
FF
I
H
L
F
B
C
O
P
E
Use Code ID
The Code ID function can be used to
identify the type of bar code that is being
scanned by inserting an identifying letter
(refer to the chart at right) at the begin-
ning of the bar code input.
For example: if the Code ID function is
on, and a bar code string of “54321” was
output as “M54321”, the bar code would
thus be identified as type Code 39.
Default is “No”.
Double Verification
Double Verification enables the MS860 to verify the accuracy of the
output by outputting only after a specified number (from 0 to 7) of
identical results. For instance, if 3 is selected, the MS860 will not
output the bar code data until it’s obtained 4 identical scan results (the
original scan plus 3 verifying scans).
Because the MS860 normally scans at a rate of 33 scans per second,
this process should take less than a fraction of a second, even for
higher values, for good quality bar code labels.
Default is “0-Off”.
39
Step 11: You will see the screen for finished Wi-Fi Setup wizard
Step 12: Click “Finish” will allow you to print out a setup sheet,
please scan the barcode labels on it to configure your scanner.