Filter
Top Products
MS860 WiFi Manual
INTRODUCTION
SCANNER PARTS:
Red LED Flash
The scanner LED flashing red indicates the scanner has low power
and you will need to charge the scanner immediately.
Scanner LED
The MS860 has one LED indicator located on the head of the scanner
which indicates the operating status of the scanner.
Red LED is ON
When the scanner attempts to read a bar code, the LED will glow red.
Single Green LED Flash
When the scanner successfully reads a bar code the scanner LED
flashes green once, and you will hear a single beep.
Flashing Green LED
When the scanner reads a ‘start configuration’ bar code (“Enter Group
5”, for instance) and enters configuration mode, the scanner will emit
one high-low-high tone beep and the scanner’s LED will flash green.
Upon exiting configuration mode, the scanner will emit one high tone
beep, and the scanner’s LED will stop flashing.
Status LED
Buzzer
Trigger
Charge Contacts
ON / OFF Switch
5
Green LED remains ON
If scans are attempted out of range, communication will be broken,
the scanner LED will remain green, and you will hear continuous Hi-
Low beeps from the scanner when attempting to scan a bar code.
z
z
The first time when you establish the communication, the LED will
remain green before VCOM communication is established.
1. When the scanner reads a `start configuration' bar code (“Enter Group 1”, for
instance) and enters configuration mode, the scanner LED will flash green while
the scanner simultaneously gives one High-Low-High tone beep. Upon exiting
configuration mode, the scanner will give one High tone beep, and the scanner
LED will stop flashing.
2. The scanner is powered on but not yet connected to the WLAN or the
connection to the WLAN is broken.
Green LED remains ON
When the scanner is powered on and connected to the WLAN successfully.