Xantrex Technology PROsine 2.0 Projector User Manual


 
Materials List
445-0089-01-01 1–7
If any of these materials are missing or are unsatisfactory in any manner, please
contact Customer Service. See page WA–1.
Important:
p DC Wiring Enclosure
For residential installations, some installation codes may require a wiring
enclosure for DC connections and cables. (Installation procedures are shipped
with the DC Wiring Enclosure.)
p Crimp-On Ring Terminals (for DC Wiring Enclosure)
If you are using the DC Wiring Enclosure, you should use crimp-on ring
terminals on the PROsine end of your DC cables. Most box connectors (set
screw types) are too large to fit in the enclosure without the risk of the
connector shorting to the wall of the DC Wiring Enclosure. Do not use any
connector that does not provide at least 2mm clearance to the inside wall with
the wire in place and the set screw tightened.
p Series Sync Cable
If you are connecting two PROsine’s in series, you will need a Series Sync
cable. This is a standard 4-connector telephone cable and may be purchased
from most electronics retailers.
Contact Xantrex or your distributor about the Wiring Enclosure. Purchase the
crimp-on ring terminals from a local supplier.