Filter
Top Products
10 Main Menu
Wide Format Copy System User Guide 125
Usage Meters
Select the USAGE METERS option of the DIAGNOSTICS menu to view the total system usage
for documents scanned and media printed.
To view area and media usage:
1. Press the
Menu key. The MAIN MENU screen is displayed.
2. Press the
Next key until DIAGNOSTICS is highlighted.
3. Press the
Enter key to select DIAGNOSTICS. The DIAGNOSTICS menu screen is
displayed.
4. Press the
Enter key to select USAGE METERS. The USAGE METERS screen is
displayed.
The USAGE METERS screen provides Scan System area usage and media usage. Scan
System area usage is measured in square units. Media usage is measured in both linear and
square units. Units are displayed as either feet or meters depending on the display units selected
for the Scan System. Refer to "Localization" in the "Main Menu" section for complete information
about setting the display units.
Below is an example of the USAGE METERS screen. In the example, the units are displayed as
meters.
USAGE METERS
SCANNER (F
2
): 11
MEDIA LINEAR 307
MEDIA AREA 670
Usage Meters Screen
5. When finished viewing the usage information, press the
Exit key to return to the
DIAGNOSTICS menu screen.
Clear Scanner Usage
The CLEAR SCANNER USAGE option of the DIAGNOSTICS menu is for use by the Customer
Service Engineer only. It requires the entry of the diagnostic password. It allows the Customer
Service Engineer to reset to zero the usage value for documents scanned.
Scanner Diagnostics
The SCANNER DIAGNOSTICS option of the DIAGNOSTICS menu provides a sub-menu of the
following choices:
• IMAGE PATH - Enables you to validate the operation of the image processing (IP)
card and the image bar.
• SCAN BAR - Enables you to calibrate the response of the scan bar.
• FULL SYSTEM TEST - Enables you to run all applicable tests on the Scan System to
determine if it is working properly.
• WRITE NVR - Enables the Customer Service Engineer to modify the contents of the
non-volatile memory of the Scan System. The diagnostic password is required for
this function.