A SERVICE OF

logo

The WAN Port Software Menu
Page 28-43
Frame Relay Example
In the following example, port 1 on slot 4 is configured for Frame Relay. To obtain status
information for this port, enter:
wpstatus 4/1
A screen similar to the following will be displayed:
This command displays three (3) layers of information. The top section provides information
on the physical interface. The middle section provides information on the logical, or Frame
Relay, interface. The bottom section provides information on the virtual circuits associated
with this physical port.
For detailed descriptions of the fields, refer to Chapter 29 “Managing Frame Relay.”
Frame Relay Status for slot 4, port 1:
Administrative/Operational Status ..................Up/Up
Port Type........................................................Universal Serial Port
Protocol..........................................................Frame Relay
Speed Intf. Receive Receive Receive Transmit Signal
BPS Type CRC Errors Aborts Overruns Overruns Errors
======== ======= ==================== ========= ========= ========
2048000 V35DCE 0 0 0 0 0
Control DTR RTS DSR CTS DCD
Signal ON ON ON ON OFF
Frame Relay Information:
UniCast Discarded Error
Octets Frames Frames Count
=================== ======== ==========
IN 941079 0 0
Out 21334 0 0
IN+OUT 962413 0 0
Administrative/Operational Phase .... Up/Up
Last Error Type.........................................No Error Since Reset
Last Error Time.........................................0 days, 00:00:00:00
Interface failures ......................................0
Last interface failure time .........................0 days, 00:00:00:00
DLCI Information:
Admin/
DLCI Oper DLCI Frames Frames Octets Octets
Num Status Type In Out In Out
==== ====== =========== ========= ========== ========= ========
0 UP/UP Configured 1021 1021 16044 1494
31 UP/UP Learned 17716 136 2746651 12663
32 UP/DN Learned 0 0 0 0
Physical Level
Information.
Logical (Frame
Relay) Infor-
mation
Virtual Circuit
Level
Information
Displays for
serial ports
only
Applicable
to all port
types.