Filter
Top Products
Chapter 9. Dial Plan Terminal Menu
61200266L1-1 ATLAS 810
PLUS
User Manual 9-17
»» Outgoing Caller ID
Write Security: 3 Read Security: 5
Allows the user to insert a called ID to outgoing calls (coming in from
attached User equipment). If set to
6HQGýDVý3URYLGHG
, then ATLAS will for-
ward whatever ID it receives (including none). If set to
6XEVWLWXWHýLIýQRWý
SUHVHQW
, then ATLAS inserts a User-defined ID value if no value is received.
If set to
6XEVWLWXWHý$OZD\V
, then ATLAS always inserts the User-defined ID
in place of the value received.
» ID Presentation
Defines control information for the presentation of
Caller ID
(
3UHVHQWDWLRQý
$OORZHGâý3UHVHQWDWLRQý5HVWULFWHGâý1XPEHUý1RWý$YDLODEOH
).
» ID Number
Value for
Caller ID
to be sent to the Network (i.e., 256 963 8020).
» Source ID
Simplifies the creation of a
Dial Plan
in applications where the criterion for
switching calls to a certain endpoint is a function of which endpoint origi-
nated the call.
• Default value = 0. The default ID for all endpoints is 0 and all accept # s
is 0. With default values, all calls are routed based only on dialed num-
ber.
• Multiple endpoints can have the same
Source ID
.
• When creating the Call Accept list, specify a
Source ID
(s) as well as a di-
aled number or range of dialed numbers to accept.
For example, an application requires that all calls originating from Port 1 of
the Quad T1/PRI module in Slot 1 be switched to Port 4 of that same mod-
ule. Assign a unique
Source ID
(e.g., 7) to Port 1 of the module, and then
configure Port 4 to only accept calls from that unique
Source ID
(7).
»» Swap ANI/DNIS
Swaps the ANI and DNIS numbers prior to being forwarded to the attached
user equipment. ANI (Automatic Number Identification) is the billing
number of the calling party, and DNIS (Dialed Number Identification Ser-
vice) is the called party number.
Quad T1/PRI Module (User Termination/NFAS)
When you are working in the
User Termination
section of the
Dial Plan
menu,
Slot
is defined as a T1/PRI module, and
Sig
is set to NFAS, the fol-
lowing configuration menu is available (in addition to the standard User
Termination/PRI configuration menus and options):
» Secondary
Interfaces
Write security: 3; Read security: 5
Defines the additional PRI interfaces controlled by the D-channel on this
endpoint.
» Slot, Port
Write security: 3; Read security: 5
Defines the slot and port in which the additional interface terminates.
This swap occurs after the ATLAS switchboard has routed the call.
The accept number in the Dial Plan must use the number in the
DNIS position prior to swapping.