Filter
Top Products
Chapter 6. Terminal Menu and System Control
6-20 ATLAS 810
PLUS
User Manual 61200266L1-1
»» Save Config
Remotely
Write security: 3; Read security: 5
Saves the configuration file specified in
TFTP Server Filename
to the
server identified in
TFTP Server IP Address
. To start this command, enter
Y to begin or enter N to cancel.
» System Utilization
Write security: 0; Read security: 0
Displays statistics related to the ATLAS internal operating system. Please
check with ADTRAN Technical Support before attempting to use this
menu.
» System Selftest
Write security: 3; Read security: 5
Initiates a system self-test. The self-test consists of memory tests and data
integrity tests for each installed module.
»» Selftest Run
Write security: 3; Read security: 5
Runs system-wide selftest, Memory, Flash, Bootrom, and Port Tests. These
tests are disruptive to all data traffic; therefore, do not run these tests on a
unit unless data interruptions are acceptable. To confirm self-test activation,
press
Y; to cancel the self-test press N.
»» Current Test Status
Security level: 3; Read security 5
Indicates a system self-test. The self-test consists of memory tests and data
integrity tests for each installed module.
»» Current Slot/Port
Displays slot and port of the subsystem currently being tested.
Before using this command, you must have identified a valid TFTP
Server in
TFTP Server IP Address
.
Self-tests disrupt data flow.