Filter
Top Products
Chapter 6. Terminal Menu and System Control
61200266L1-1 ATLAS 810
PLUS
User Manual 6-19
To support these transfers, ADTRAN delivers a TFTP program with
ATLAS 810
PLUS
called TFTP Server. You can configure any PC running Mi-
crosoft Windows with this software, and store a configuration file. See TFTP
Server on page 12-10 for details on how to use TFTP Server.
Only one configuration transfer session (upload or download) can be active
at a time. The TCP/IP parameters are not saved or overwritten as part of an
ATLAS 810
PLUS
unit’s transferred configuration; this way, identical config-
urations can be sent to multiple units.
»» Transfer Method
Write security: 3; Read security: 5
Displays the method used to transfer the configuration file to or from a
server. Currently, you must use TFTP.
»» TFTP Server IP
Address
Write security: 3; Read security: 5
Specifies the IP address of the TFTP Server. Get this number from your sys-
tem administrator.
»» TFTP Server
Filename
Write security: 3; Read security: 5
Defines the name of the configuration file that you transfer to or retrieve
from the TFTP Server. The default name is
atlas.cfg, but you can edit this
name.
»» Current Transfer
Status
Read security: 5
Indicates the current status of the update.
»» Previous Transfer
Status
Read security: 5
Indicates the status of the previous update.
»» Load and Use Config
Write security: 3; Read security: 5
Retrieves the configuration file specified in the
TFTP Server Filename field
from the server. To start this command, enter
Y to begin or enter N to cancel.
Before using
Config Transfer
, the ATLAS 810
PLUS
should have a
valid IP address, subnet mask, and default gateway (if required),
and should be connected to an Ethernet network.
If you execute
Load and Use Config
, the ATLAS 810
PLUS
retrieves the configuration file, reboots, then restarts using the new
configuration.