Filter
Top Products
Chapter 6. Terminal Menu and System Control
61200266L1-1 ATLAS 810
PLUS
User Manual 6-9
» Chain Port
Write security: 2; Read security: 5
Accepts input for configuring the Chain In port.
»» Port Name
Write security: 2; Read security: 5
Defines the name of the chain port. Type in an alpha-numeric name up to 57
characters long. The name can include spaces and special characters.
»» Port Type
Write security: 2; Read security: 5
Specifies whether you use
Direct or Dial mode.
»» Port Speed
Write security: 2; Read security: 5
Specifies the baud rate of the port. Select either 2400, 9600, 19200, or 38400.
If you are using
Dial for
Port Type
, ensure that the
Port Speed
setting
matches the modem baud rate.
»» Modem Initialization
String
Write security: 2; Read security: 5
Specifies the initialization string for a modem. Refer to your modem docu-
mentation for acceptable initialization strings.
»» Initialize Modem
Write security: 4; Read security: 5
Sends the Modem Initialization string to the modem. When you select this
command, the following message displays:
Please verify a modem is con-
nected to the chain port before continuing. Confirm (y/n).
ý
Ensure that a
modem is connected before selecting
Y.
»» Flow Control
Write security: 2; Read security: 5
Sets the flow control for the Chain In port. You may configure the Chain In
port flow control for
OFF
or
H/W
(hardware).
» SNMP
Write security: 3; Read security: 5
Provides a way to configure SNMP access for the ATLAS 810
PLUS
. For
detailed information on SNMP, refer to SNMP Management on page 11-1.
The following options are available for review and editing:
»» SNMP Access
Write security: 3; Read security: 5
Defines whether SNMP access to the ATLAS 810
PLUS
is enabled or disabled.
Select the appropriate option.
»» SNMP Communities
Write security: 3; Read security: 5
Defines SNMP manager(s) characteristics as follows:
IP Address
Specifies the IP address of the network manager.
Privileges
Defines Get (read-only) and Get/Set (read and write) privileges.
Get Name
Defines the community name for Get access. This value must match the Get
name defined on the network management station. Public is the default
name.
Set Name
Defines the community name for Set access. This value must match either
the Get or Set name defined on the network management station. Public is
the default name.