Filter
Top Products
Chapter 3. Operation
61200266L1-1 ATLAS 810
PLUS
User Manual 3-3
USING TELNET
To connect to the ATLAS 810
PLUS
via Telnet, you must define the IP address,
set the subnet mask, and, typically, set the default gateway IP address.
Starting a Telnet Session
When you begin the Telnet session, you will be prompted for a password.
The default password is
password
(which is a Level 0 superuser password).
You can change this password using the
Access Passwords
option, which
is only accessible through the terminal menus. See Access Passwords on page
6-13 for details. The Telnet session will time out and display the Login
prompt after a pre-defined time that is set in the
Session Timeout
option
(see Session Timeout on page 6-8 for details).
USING T-WATCH PRO
T-Watch PRO is the ADTRAN Microsoft Windows management software
program designed to control TSU units from a remote PC. It provides limit-
ed control over the configuration of the ATLAS 810
PLUS
using a graphic in-
terface. Currently, you can choose ATLAS 810
PLUS
from a list of products,
and T-Watch PRO automatically initiates a Telnet session by which you can
connect to and manage the ATLAS 810
PLUS
Base Unit. At this time,
T-Watch PRO automatically receives SNMP traps from an ATLAS 810
PLUS
.
You must define the IP address before attempting to connect via
Telnet. See Using VT-100 Terminal Emulation on page 3-1 for
details on defining the IP address.
You will need a default gateway if the LAN contains multiple
segments. Contact your LAN administrator for the appropriate
address.
Use the
Max Telnet Sessions
option to define the number of
Telnet sessions that can be active at one time (see Max Telnet
Sessions on page 6-8 for details).
Microsoft Telnet version 1.0 does not implement full VT-100
emulation. However, many commercial Telnet clients for Microsoft
Windows exist which fully implement VT-100. In addition, a
freeware client, recommended for optimum performance, comes with
the ATLAS 810
PLUS
. See VT-100 Utility on page 12-8 for details.