Filter
Top Products
Chapter 9. Dial Plan Terminal Menu
61200266L1-1 ATLAS 810
PLUS
User Manual 9-21
Calls
The number of calls (1 or 2) which can be received or sent on this number/
SPID.
D64, D56, Audio,
Speech
These options reflect what the Network has provisioned for this SPID. If the
BRI was purchased with different services provisioned for the SPIDs, then
the call must match the services supported.
Octal BRI Module (User Termination)
The Octal BRI with a “U” interface acts as the Network while interfacing to
user equipment (terminal adapters). When you are working in the
User Ter-
mination
section of the
Dial Plan
menu and
Slot
is defined as a UBRI-8
module, the following interface configuration options are available:
»» Switch Type
Write security: 2; Read security: 5
Defines the type of ISDN switch that ATLAS will simulate. If connected to
another ATLAS, both need to be set to the same type. The available options
include Lucent 5E, Northern DMS 100, and National ISDN.
»» SPID List
Write security: 2; Read security: 5
ATLAS, acting as the Network, must use a SPID and a phone number in or-
der to satisfy the ISDN connection protocol expected by the User’s Terminal
Adapter (TA).
Phone Number
The phone number(s) assigned to this BRI phone line.
SPID Number
Defines the SPID number(s) which will be used for this BRI line. Although
the value of the SPID is not significant, a SPID must be entered for each
phone number. For convenience, the SPID can be set to be the same as the
phone number.
Calls
For User terminations, the number of calls is fixed at 2.
D64, D56, Audio,
Speech
Reflects what the Network has provisioned for this SPID. If the BRI was pur-
chased with different services provisioned for the SPIDs, then the call must
match the services supported.
ATLAS 810
PLUS
does not support autoSPID detection software
which some terminal adapters offer.