Filter
Top Products
Chapter 10. Updating Firmware
61200266L1-1 ATLAS 810
PLUS
User Manual 10-5
When the update process has successfully completed,
Idle
displays in
Cur-
rent Update Status
, and
Module Update Complete
displays in
Previous
Update Status
. Either the module restarts immediately and resumes opera-
tion, or it restarts at the specified time and day of the week—depending on
your selection.
If an error occurred during the update process,
Previous Update Status
displays the appropriate error message. In this case, return to step 3 and at-
tempt the update process again. If the same error occurs, contact ADTRAN
Technical Support.
9
Select
Begin Firmware Update
to start the update process. Enter
Y
to confirm the transfer and to set up the module to receive the
TFTP upload.
10
To update additional modules, begin at step 3 and repeat this
process.
During the TFTP upload process, various status messages display in
Current Update Status
to indicate progress. Table 10-1 describes
these messages.
Instructions for Updating Firmware Using TFTP
(Continued)
Step Action
Table 10-1. TFTP Upload Messages
Message Meaning
Contacting Server Indicates communication with the TFTP Network Server is trying to be
established with the specified server address in the TFTP Server IP
Address field.
Beginning TFTP Transfer Indicates communication with the TFTP Network Server has been
established and the update file is being transferred between ATLAS
and the TFTP Network Server.
Completed Indicates the ATLAS product successfully received the update file.
Error: File Not Found Indicates the TFTP Network Server was unable to locate the specified
file name or path in the TFTP Server Filename field.
Error: Access Violation Indicates the TFTP Network Server denied ATLAS access to the given
update file name and path. Please verify appropriate user rights are
selected for the specified path.
Error: Illegal Operation An unknown operation was detected by ATLAS when transferring the
update file from the TFTP Network Server.
Error: User Aborted Indicates the user selected Cancel Update to abort reception of the
update file from the TFTP Network Server.