Filter
Top Products
Chapter 3. Operation
3-2 ATLAS 810
PLUS
User Manual 61200266L1-1
When you begin the VT-100 session, you will be prompted for a password.
The default password is
password
(which is a Level 0 superuser password).
You can change this password using the
Access Passwords
option, which
is only accessible through the terminal menu. See Access Passwords on page
6-13 for details. After your password is accepted, define the IP Address of
the ATLAS 810
PLUS
to which you want to connect. The following Step/Ac-
tion chart describes this process.
Instructions for Setting Up an ATLAS 810
PLUS
for VT-100 Terminal Mode
Step Action
1
Set the baud rate on the VT-100 terminal to 9600 baud (8/N/1).
2
Use the ADTRAN-provided VT-100 terminal adapter to connect
the
COM
port of a VT-100 compatible terminal, or equivalent, to
the eight-pin modular jack labeled
CONTROL/CHAIN IN
on the
rear panel
or
labeled
CRAFT
on the front panel.
This connection provides both local and remote configuration.
3
Repeatedly press
Enter
on the keyboard until the
Login
menu
requiring a password appears.
4
If necessary, press
Ctrl-R
to refresh the display.
Instructions for Defining the IP Address
Step Action
1
Obtain an IP address for the ATLAS 810
PLUS
from your LAN
administrator.
2
Use the ADTRAN-provided VT-100 terminal adapter to connect
the
COM
port of a VT-100 compatible terminal, or equivalent, to
the eight-pin modular jack labeled
CONTROL/CHAIN IN
on the
rear panel
or
labeled
CRAFT
on the front panel.
This connection provides both local and remote configuration.
3
Repeatedly press
System
on the front panel until the
Login
menu appears. Enter your password.
4
When the terminal menu opens, navigate the following path:
ATLAS 810PLUS / System Config / Ethernet port / IP Address
5
Key in the entire IP address, and then press
Enter
.
You will need a default gateway if the LAN contains multiple
segments. Contact your LAN administrator for the appropriate
address.