Filter
Top Products
Figure 5-6: Save the information of connected modules to txt file.... 5-12
Figure 5-7: Setup options ..................................................................5-12
Figure 5-8: Checksum function enabled ..........................................5-15
Figure 5-9: The connection for the Data Scope function ..................5-16
Figure 5-10: Monitor the issuing commands from PC#1 ...................5-17
Figure 6-1: Baud rate codes................................................................ 6-6
Figure 6-2: Analog module error codes ............................................ 6-18
Figure 6-3: Data format for 8-bit parameters ....................................6-38
Figure 6-4: Data format of 8-bit parameters .....................................6-92
Figure A-1: Power supply connections ............................................... A-4
Figure A-2: ADAM-5000 system hook-up and configuration ............... A-6
Figure A-3: Grounding the INIT* terminal ..........................................A-10
Figure A-4: ADAM-5000 network system hook-up ............................ A-11
Figure C-1: Daisychaining .................................................................. C-3
Figure C-2: Star structure.................................................................... C-4
Figure C-3: Random structure ............................................................ C-5
Figure C-4: ADAM-4000 and ADAM-5000 in a network ...................... C-6
Figure C-5: Signal distortion ............................................................... C-7
Figure C-6: Termination resistor locations......................................... C-8
Figure C-7: RS-485 data flow control with RTS .................................. C-9
Figure E-1: Grounding Scheme ......................................................... E-2
Figure E-2: External Terminal Block and Fan..................................... E-3
Figure E-3: Grounding for on-site facilities and ADAM-5000/4000
Systems ........................................................................... E-4
Figure E-4: Grounding for signal wires .............................................. E-4
Figure E-5 : Grounding Reference ...................................................... E-5
Figure F-1: Think the EARTH as GROUND......................................... F-3
Figure F-2: Grounding Bar. .................................................................. F-4
Figure F-3: Normal mode and Common mode. ................................. F-5
Figure F-4: Normal mode and Common mode. ................................. F-6
Figure F-5: The purpose of high voltage transmission ...................... F-7
Figure F-6: wire impedance. ............................................................... F-7
Figure F-7: Single point groundinF. (1) ...............................................F-8
Figure F-8: Single point groundinF. (2) ...............................................F-9
Figure F-9: Single isolated cable ........................................................F-9
Figure F-10: Double isolated cable.....................................................F-10