Filter
Top Products
5-6 ADAM-5000
Software Utilities
Calibration
Press <Enter> on the Calibrate option on the top bar and a selection
bar appears in the status field. Move the selection bar over the
module you wish to configure and select it by pressing <Enter>. Only
analog input and output modules can be calibrated. If the module is an
analog input module, you will be able to choose, for example, Zero
Calibration. The screen will then look like Figure 5-3.
Figure 5-3 Zero Calibration
File
This option allows you to update the status field using the Save
option and can give you a hardcopy of all the connected modules that
are shown on the screen by using the Print option.
Terminal
This option allows you to directly send and receive commands on the
RS-485 line. It has two options: Command Test and Terminal Emula-
tion.
Choose the Single Line option to use the Command Test mode. You
send commands one at a time by typing them on the Command line
and pressing <Enter>. The response appears in the Response line