Filter
Top Products
ADAM-5000 5-3
Chapter 5
Figure 5-1 Main screen
Normally you will use the Search command to scan the network.
Highlight the Search command on the menu bar and press <Enter> (or
simply press the "s" key). The "Search Installed Modules" window
will then appear to prompt you to enter the range it should scan. Input
a value between 0 and 256 decimal.
Note: When changing configuration, calibration or alarm
parameters, you should always make sure that a
window appears notifying you that the target module
has confirmed the changes.
An asterix sign "*" before the module's address
indicates that the module is in the INIT* state.
Setup
Select Setup from the top bar and a selection bar will appear in the
status field. First, move the selection bar over the module you wish to
configure and select it by pressing <Enter>. A configuration screen
will appear with the setting available for its module type and the