Filter
Top Products
ADAM-5000 4-35
Chapter 4
Digital Output Holding Function
A yellow mini jumper is added to the PCB, the major function of which
is to hold the digital output value at its last status so that it won't be
erased when the RESET button of your system is pressed or your
system software going into reset.
To enble your Digital Output Holding Funciton, you must first set the
yellow mini jumper on. When the Digital Output Holding Function is
enabled, the digital output value of ADAM-5060D will first be cleared
during system power-on. When the RESET button is pressed or when
a system software reset occurs, its digital output value will be held at
the last value.
To disable your Digital Output Holding Funciton, you must set the
mini jumper off. When the jumper is off, it's functions just like an
ADAM-5056.
Figure 4-35: ADAM-5056D Application Wiring
limits current to 100 mA
Power
Ground
Power
Ground
+Vss
-Vss