Filter
Top Products
User Documentation Addendum vlan port-mac bandwidth
Release 5.1.6.R02 User Guide Supplement June 2005 page 1-5
vlanHAPortTable
vlanHAPortVlanId
vlanHAPortType
vlanHAPortIfIndex
slMacToPortMacTable
vlanHAPortVlanId
slMacToPortMacAddress
vlanTable
vlanNumber
Chapter 42, “802.1X Commands”
On page 42-11 replace the Examples section for the show 802.1x command with the following:
-> show 802.1x 1/13
802.1x configuration for slot 1 port 13:
direction = both,
operational directions = both,
port-control = auto,
quiet-period (seconds) = 60,
tx-period (seconds) = 30,
supp-timeout (seconds) = 30,
server-timeout (seconds) = 30,
max-req = 2,
re-authperiod (seconds) = 3600,
reauthentication = no
Guest Vlan ID = 20,
Supplicant polling retry count = 2
On page 42-12 the following two new field definitions should be added to the Output Definitions table
for the show 802.1x command:
On page 42-13 the following MIB information should be added to the MIB Objects section for the
show 802.1x command:
alaDot1xGuestVlanConfTable
alaDot1xGuestVlanNumber
alaDot1xSuppPollingCnt
The following three new commands should be included in this chapter:
Guest VLAN ID
Indicates if a guest VLAN is configured for non-802.1x traffic received
on the port. If so, a VLAN ID number appears in this field. Configured
through the 802.1x guest-vlan command This field does not appear on
an OmniSwitch 6800.
Supplicant polling retry
count
The number of times a device is polled for EAP frames to determine
whether or not the device is an 802.1x client. Configured through the
802.1x supp-polling retry command. This field does not appear on an
OmniSwitch 6800.