Filter
Top Products
show 802.1x non-supp User Documentation Addendum
page 1-16 Release 5.1.6.R02 User Guide Supplement June 2005
The following example command configures a BGP peering session using a Loopback0 IP interface
address:
-> ip bgp neighbor 2.2.2.2 update-source Loopback0
See the OmniSwitch 7700/7800/8800 Network Configuration Guide for more information about configur-
ing an IP Loopback0 interface.
OmniSwitch 6600 Family Network Configuration
Guide
The following modifications should be made:
Chapter 21, “Configuring 802.1X”
Quick Steps for Configuring 802.1X
On page 21-3 the following two new steps should be added to this section:
6 (Optional) Configure a guest VLAN for the 802.1x port using the 802.1x guest-vlan command.
-> 802.1x 3/1 guest-vlan 5
7 (Optional) Configure the number of times supplicant devices are polled for identification using the
802.1x supp-polling retry command.
-> 802.1x 3/1 supp-polling retry 10
On page 22-3 of this section replace the Note information about how to display 802.1x configuration and
user information with the following:
Note. Verify the 802.1X port configuration using the show 802.1x command:
-> show 802.1x 1/13
802.1x configuration for slot 1 port 13:
direction = both,
operational directions = both,
port-control = auto,
quiet-period (seconds) = 60,
tx-period (seconds) = 30,
supp-timeout (seconds) = 30,
server-timeout (seconds) = 30,
max-req = 2,
re-authperiod (seconds) = 3600,
reauthentication = no
Guest Vlan ID = 20,
Supplicant polling retry count = 2
Optional. To display the number of 802.1x users on the switch, use the show 802.1x users command: