ipv6 rip interface metric IPv6 Commands
page 2-66 Release 5.1.6.R02 User Guide Supplement June 2005
ipv6 rip interface metric
Configures the RIPng metric or cost for a specified interface. You can set priorities for routes generated by
a switch by assigning a metric value to routes generated by that switch’s RIPng interface. For example,
routes generated by a neighboring switch may have a hop count of 1. However, you can lower the priority
of routes generated by that switch by increasing the metric value for routes generated by the RIPng inter-
face.
ipv6 rip interface if_name metric value
Syntax Definitions
if_name IPv6 interface name.
value Metric value. Valid range is 1 - 15.
Defaults
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
When you configure a metric for a RIPng interface, this metric cost is added to the metric of the incoming
route.
Example
-> ipv6 rip Test_Lab metric 1
Release History
Release 5.1.6; command was introduced.
Related Commands
MIB Objects
alaRipngInterfaceTable
alaRipngInterfaceMetric
parameter default
value 1
ipv6 rip interface Creates/deletes a RIPng interface.
show ipv6 rip interface Displays information for all or specified RIPng interfaces.