Filter
Top Products
show ipv6 neighbors IPv6 Commands
page 2-38 Release 5.1.6.R02 User Guide Supplement June 2005
show ipv6 neighbors
Displays IPv6 Neighbor Table.
show ipv6 neighbors [ipv6_prefix/prefix_length | if_name | hw hardware_address | static]
Syntax Definitions
ipv6_prefix/prefix_length IPv6 prefix. Restricts the display to those neighbors starting with the
specified prefix.
if_name Interface name. Restricts the display to those neighbors reached via the
specified interface.
hardware_address MAC address. Restricts the display to the specified MAC address.
static Restricts display to statically configured neighbors.
Defaults
N/A.
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
If you do not specify an option (e.g., if_name), all IPv6 neighbors are displayed.
Example
-> show ipv6 neighbors
IPv6 Address Hardware Address State Type Port Interface
----------------------------+-------------------+----------+-------+-----+---------
fe80::02d0:c0ff:fe86:1207 00:d0:c0:86:12:07 Probe Dynamic 1/15 vlan_4
fe80::020a:03ff:fe71:fe8d 00:0a:03:71:fe:8d Reachable Dynamic 1/ 5 vlan_17
output definitions
IPv6 Address The neighbor’s IPv6 address.
Hardware Address The MAC address corresponding to the IPv6 address.
State The neighbor’s state:
- Unknown
- Incomplete
- Reachable
- Stale
- Delay
- Probe.
Type Indicates whether the neighbor entry is a Static or Dynamic entry.
Port The port used to reach the neighbor.
Interface The neighbor’s interface name (e.g., vlan_1)