Filter
Top Products
IPv6 Commands ipv6 rip interface recv-status
Release 5.1.6.R02 User Guide Supplement June 2005 page 2-67
ipv6 rip interface recv-status
Configures IPv6 RIPng interface “Receive” status. When this status is set to "enable", packets can be
received on this interface. When it is set to "disable", packets will not be received on this interface.
ipv6 rip interface if_name recv-status {enable | disable}
Syntax Definitions
if name IPv6 interface name.
enable | disable Interface “Receive” status.
Defaults
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
RIPng must be loaded (ipv6 load rip) and enabled (ipv6 rip status)on the switch to send or receive pack-
ets on the interface.
Example
-> ipv6 rip interface Test_Lab recv-status disable
Release History
Release 5.1.6; command was introduced.
Related Commands
MIB Objects
alaRipngInterfaceTable
alaRipngInterfaceRecvStatus
parameter default
enable | disable enable
ipv6 load rip Loads RIPng into memory.
ipv6 rip status Enables/disables RIPng on the switch.
ipv6 rip interface send-status Configures IPv6 RIPng interface “Send” status.