ipv6 rip jitter IPv6 Commands
page 2-60 Release 5.1.6.R02 User Guide Supplement June 2005
ipv6 rip jitter
Configures an offset value for RIPng updates. This is the maximum (positive or negative) value that can
be used to offset the update interval. For example, with an update interval of 30 seconds, and a jitter value
of 5 seconds, the RIPng update packet would be sent somewhere (random) between 25 and 35 seconds
from the previous update.
ipv6 rip jitter value
Syntax Definitions
value Time, in seconds, that a routing update is offset. Valid range is 0 to one-
half the updated interval value (e.g., if the updated interval is 30, the
range would be 0 - 300).
Defaults
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
As you increase the number of RIPng interfaces/peers, it is recommended that you increase the Jitter value
to reduce the number of RIPng updates being sent over the network.
Example
-> ipv6 rip jitter 10
Release History
Release 5.1.6; command was introduced.
Related Commands
MIB Objects
alaProtocolripng
alaRipngJitter
parameter default
value 5
ipv6 rip update-interval Configures the RIPng update interval.
show ipv6 rip Displays RIPng status and general configuration information.