Filter
Top Products
ipv6 rip garbage-timer IPv6 Commands
page 2-58 Release 5.1.6.R02 User Guide Supplement June 2005
ipv6 rip garbage-timer
Configures the RIPng garbage timer value. When a route in the RIB exceeds the configured Invalid Timer
Value, the route is moved to a “Garbage” state in the the RIB. The garbage timer is the length of time a
route will stay in this state before it is flushed from the RIB.
ipv6 rip garbage-timer seconds
Syntax Definitions
seconds Time, in seconds, that a route will remain in the RIPng Routing Table
before it is flushed from the RIB. Valid range is 0 - 180.
Defaults
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
Use the ipv6 rip invalid-timer command to set the Invalid Timer Value.
Example
-> ipv6 rip garbage-timer 180
Release History
Release 5.1.6; command was introduced.
Related Commands
MIB Objects
alaProtocolripng
alaRipngGarbageTimer
parameter default
seconds 120
ipv6 rip invalid-timer Configures the amount of time a route remains active in RIB before
being moved to the "Garbage" state.
ipv6 rip holddown-timer Configures the amount of time a route is placed in a holddown state.