Filter
Top Products
IPv6 Commands ipv6 rip interface horizon
Release 5.1.6.R02 User Guide Supplement June 2005 page 2-69
ipv6 rip interface horizon
Configures the routing loop prevention mechanisms.
ipv6 rip interface if_name horizon {none | split-only | poison}
Syntax Definitions
if_name IPv6 interface name.
none | split-only | poison none - Disables loop prevention mechanisms.
split-only - Enables split-horizon, without poison-reverse.
poison - Enables split-horizon with poison-reverse.
Defaults
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
• If set to “none” the route is not sent back to the peer.
• If set to ‘split-only”, the route received from the peer is sent back with an increased metric.
• If set to “poison” the route received from the peer is sent back with an “infinity” metric.
Example
-> ipv6 rip interface Test_Lab none
Release History
Release 5.1.6; command was introduced.
Related Commands
MIB Objects
alaRipngInterfaceTable
alaRipngInterfaceHorizon
parameter default
none | split-only | poison poison
show ipv6 rip interface Displays information for all or specified RIPng interfaces.
show ipv6 rip routes Displays all or a specific set of routes in the RIPng Routing Table.