IPv6 Commands ipv6 rip triggered-sends
Release 5.1.6.R02 User Guide Supplement June 2005 page 2-63
ipv6 rip triggered-sends
Configures the behavior of triggered updates.
ipv6 rip triggered-sends {all | updated-only | none}
Syntax Definitions
all All RIPng routes are added to any triggered updates.
updated-only Only route changes that are causing the triggered update are included in
the update packets.
none RIPng routes are not added to triggered updates.
Defaults
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
• If set to “all”, all routes are sent in the update, not just route changes, which increases RIPng traffic on
the network.
• If set to “none”, no triggered updates are sent, which can cause delays in network convergence.
Example
-> ipv6 rip triggered-sends none
Release History
Release 5.1.6; command was introduced.
Related Commands
MIB Objects
alaProtocolripng
alaRipngTriggeredSends
parameter default
all | updated-only | none updated-only
show ipv6 rip Displays RIPng status and general configuration information.