Alcatel Carrier Internetworking Solutions 6600 Switch User Manual


 
ipv6 rip interface send-status IPv6 Commands
page 2-68 Release 5.1.6.R02 User Guide Supplement June 2005
ipv6 rip interface send-status
Configures IPv6 RIPng interface “Send” status. When this status is set to "enable", packets can be sent
from this interface. When it is set to "disable", packets will not be sent from this interface.
ipv6 rip interface if_name send-status {enable | disable}
Syntax Definitions
if name IPv6 interface name.
enable | disable Interface “Send” status.
Defaults
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
RIPng must be loaded (ipv6 load rip) and enabled (ipv6 rip status)on the switch to send or receive pack-
ets on the interface.
Example
-> ipv6 rip interface Test_Lab send-status enable
Release History
Release 5.1.6; command was introduced.
Related Commands
MIB Objects
alaRipngInterfaceTable
alaRipngInterfaceSendStatus
parameter default
enable | disable enable
ipv6 load rip Loads RIPng into memory.
ipv6 rip status Enables/disables RIPng on the switch.
ipv6 rip interface recv-status Configures IPv6 RIPng interface “Receive” status.