Filter
Top Products
Configuration Commands
Page 118 7750 SR OS Router Configuration Guide
Parameters mtu-bytes — Specify the MTU for the nodes to use to send packets on the link.
Values 1280 — 9212
other-stateful-configuration
Syntax [no] other-stateful-configuration
Description This command sets the "Other configuration" flag. This flag indicates that DHCPv6lite is available
for autoconfiguration of other (non-address) information such as DNS-related information or
information on other servers in the network. See RFC 3736, Stateless Dynamic Host Configuration
Protocol (DHCP) for IPv6.
Default no other-stateful-configuration
prefix
Syntax [no] prefix [ipv6-prefix/prefix-length]
Context config>router>router-advert>if
Description This command configures an IPv6 prefix in the router advertisement messages. To support multiple
IPv6 prefixes, use multiple prefix statements. No prefix is advertised until explicitly configured using
prefix statements.
Default none
Parameters ip-prefix — The IP prefix for prefix list entry in dotted decimal notation.
Values ipv4-prefix a.b.c.d (host bits must be 0)
ipv4-prefix-length 0 — 32
ipv6-prefix x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 — FFFF]H
d: [0 — 255]D
ipv6-prefix-length 0 — 128
prefix-length — Specifies a route must match the most significant bits and have a prefix length.
Values 1 — 128
autonomous
Syntax [no] autonomous
Context config>router>router-advert>if>prefix
Description This command specifies whether the prefix can be used for stateless address autoconfiguration.
Default enabled