Filter
Top Products
Configuration Commands
Page 94 7750 SR OS Router Configuration Guide
Default 5
Values 1 — 255
enable — Static routes can be administratively enabled or disabled. Use the enable parameter to re-
enable a disabled static route. In order to enable a static route, it must be uniquely identified by
the IP address, mask, and any other parameter that is required to identify the exact static route.
The administrative state is maintained in the configuration file.
Default enable
disable — Static routes can be administratively enabled or disabled. Use the disable parameter to
disable a static route while maintaining the static route in the configuration. In order to enable a
static route, it must be uniquely identified by the IP address, mask, and any other parameter that
is required to identify the exact static route.
The administrative state is maintained in the configuration file.
Default enable
bfd-enable — Associates the state of the static route to a BFD session between the local system and
the configured nexthop. This keyword cannot be configured if the nexthop is indirect or
blackhole keywords are specified.
mcast-ipv4 — Specifies peers that are IPv4 multicast capable.
Static-route 5 Yes
OSPF Internal routes 10 Yes
IS-IS level 1 internal 15 Yes
IS-IS level 2 internal 18 Yes
OSPF External 150 Yes
IS-IS level 1 external 160 Yes
IS-IS level 2 external 165 Yes
BGP 170 Yes
Table 5: Default Route Preferences
Route Type Preference Configurable