Filter
Top Products
List of Commands
Page 306 7750 SR OS Router Configuration Guide
dot1p
Configures an IEEE 802.1p value or range to be used as a MAC filter
match criterion.
383
etype
Configures an Ethernet type II Ethertype value to be used as a MAC filter
match criterion.
385
dsap
Configures an Ethernet 802.2 LLC DSAP value or range for a MAC filter
match criterion.
383
ssap
Configures an Ethernet 802.2 LLC SSAP value or range for a MAC filter
match criterion.
387
snap-pid
Configures an IEEE 802.3 LLC SNAP Ethernet Frame PID value to be
used as a MAC filter match criterion.
386
snap-oui
Configures an IEEE 802.3 LLC SNAP Ethernet Frame OUI zero or non-
zero value to be used as a MAC filter match criterion.
385
Configure a redirect policy
config>filter
redirect-policy
Enables the context to redirect policies. 359
description
Creates a text description stored in the configuration file for a
configuration context.
357
destination
Specifies a cache server destination (an IP address) to redirect packets
matching IP filter entry criteria.
390
ping-test
The context to configure connectivity ping tests to validate the ability of
the destination to receive redirected traffic.
390
drop-count
Specifies the number of consecutive ping test failures before declaring the
destination down.
390
interval
The frequency at which the ping test, SNMP test, or URL test is executed. 391
timeout
Specifies the amount of time in seconds that is allowed for receiving a
response from the far-end host.
391
priority
The destination’s priority describes its relative importance within the
policy. If more than one destination is specified, the destination with the
highest priority value is selected.
391
snmp-test
The context to configure SNMP test parameters. 392
oid
The OID of the object to be fetched from the destination. 392
return-value
Specifies the criterion to adjust the priority based on the test result. 392
url-test
The context to enable URL test parameters. 393
url
Specifies the URL to be probed by the URL test. 394
Table 18: CLI Commands to Configure Filter Policies Parameters (Continued)
Command Description Page