Filter
Top Products
106 AT-WR4500 Series - IEEE 802.11abgh Outdoor Wireless Routers
RouterOS v3 Configuration and User Guide
Assign IP addresses to these interfaces:
[admin@OSPF_peer_1] ip address> print
Flags: X - disabled, I - invalid, D - dynamic
# ADDRESS NETWORK BROADCAST INTERFACE
0 10.1.0.1/24 10.1.0.0 10.1.0.255 to_main
1 10.3.0.1/24 10.3.0.0 10.3.0.255 backup
Set redistribute-connected as as-type-1. Metric-connected, metric-static, metric-rip, metric-bgp should be
zero.
[admin@OSPF_peer_1] routing ospf> print
router-id: 0.0.0.0
distribute-default: never
redistribute-connected: as-type-1
redistribute-static: no
redistribute-rip: no
redistribute-bgp: no
metric-default: 1
metric-connected: 0
metric-static: 0
metric-rip: 0
metric-bgp: 0
Add the same area as in main router:
[admin@OSPF_peer_1] routing ospf area> print
Flags: X - disabled, I - invalid
# NAME AREA-ID STUB DEFAULT-COST
AUTHENTICATION
0 backbone 0.0.0.0 none
1 local_10 0.0.0.1 no 1 none
Add connected networks with area local_10:
[admin@OSPF_peer_1] routing ospf network> print
Flags: X - disabled, I - invalid
# NETWORK AREA
0 10.3.0.0/24 local_10
1 10.1.0.0/24 local_10
Finally, set up the OSPF_peer_2 router. Enable the following interfaces:
[admin@OSPF_peer_2] interface> print
Flags: X - disabled, D - dynamic, R - running
# NAME TYPE RX-RATE TX-
RATE MTU
0 R to_main ether 0 0
1500
1 R to_peer_1 ether 0 0
1500
Add the needed IP addresses:
[admin@OSPF_peer_2] ip address> print
Flags: X - disabled, I - invalid, D - dynamic
# ADDRESS NETWORK BROADCAST INTERFACE
0 10.2.0.1/24 10.2.0.0 10.2.0.255 to_main
1 10.3.0.2/24 10.3.0.0 10.3.0.255 to_peer_1