Filter
Top Products
232 AT-WR4500 Series - IEEE 802.11abgh Outdoor Wireless Routers
RouterOS v3 Configuration and User Guide
This is an ordered list, so you can put more specific entries on the top of the list for them to override
more common rules that appear lower. You can even put an entry with 0.0.0.0/0 address at the end of
the list to make the desired action default for those addresses that will not match any other entry.
10.3.6 Active Host List
Submenu level: /ip hotspot host
Description
This menu shows all active network hosts that are connected to the HotSpot gateway. This list includes
all one-to-one NAT translations
Property Description
address (read-only: IP address) - the original IP address of the client
authorized (read-only: flag) - whether the client is successfully authenticated by the HotSpot system
bridge-port (read-only: name) - the actual physical interface, which the host is connected to. This is used
when HotSpot service is put on a bridge interface to determine the host's actual port within the bridge.
bypassed (read-only: flag) - whether the client does not need to be authorized by the HotSpot system
bytes-in (read-only: integer) - how many bytes did the router receive from the client
bytes-out (read-only: integer) - how many bytes did the router send to the client
found-by (read-only: text) - how was this host discovered (first packet type, sender, recipient)
host-dead-time (read-only: time) - how long has the router not received any packets (including ARP
replies, keepalive replies and user traffic) from this host
idle-time (read-only: time) - the amount of time has the user been idle
idle-timeout (read-only: time) - the exact value of idle-timeout that applies to this user. This property
shows how long should the user stay idle for it to be logged off automatically
keepalive-timeout (read-only: time) - the exact value of keepalive-timeout that applies to this user.
This property shows how long should the user's computer stay out of reach for it to be logged off
automatically
mac-address (read-only: MAC address) - the actual MAC address of the user
packets-in (read-only: integer) - how many packets did the router receive from the client
packets-out (read-only: integer) - how many packets did the router send to the client
server (read-only: name) - name of the server, which the host is connected to
static (read-only: flag) - whether this translation has been taken from the static IP binding list
to-address (read-only: IP address) - what address is the original IP address of the host translated to
uptime (read-only: time) - current session time of the user (i.e., how long has the user been in the active
host list)
10.3.7 Command Description
make-binding - copy a dynamic entry from this list to the static IP bindings list
Input Parameters
unnamed (name) - item number
comment (text) - custom comment to the static entry to be created
type (regular | bypassed | blocked) - the type of the static entry
10.3.8 Service Port
Submenu level: /ip hotspot service-port
Description
Just like for classic NAT, the HotSpot embedded one-to-one NAT 'breaks' some protocols that are
incompatible with address translation. To leave these protocols consistent, helper modules must be used.
For the one-to-one NAT the only such a module is for FTP protocol.