Filter
Top Products
AT-WR4500 Series - IEEE 802.11abgh Outdoor Wireless Routers 173
RouterOS v3 Configuration and User Guide
Example
To add and enable PPPoE client on the gig interface connecting to the AC that provides testSN service
using user name john with the password password:
[admin@RemoteOffice] interface pppoe-client> add interface=gig \
\... service-name=testSN user=john password=password disabled=no
[admin@RemoteOffice] interface pppoe-client> print
Flags: X - disabled, R - running
0 R name="pppoe-out1" max-mtu=1480 max-mru=1480 mrru=disabled interface=ether1
user="user" password="passwd" profile=default service-name="testSN"
ac-name="" add-default-route=no dial-on-demand=no use-peer-dns=no
allow=pap,chap,mschap1,mschap2
[admin@RemoteOffice] interface pppoe-client>
8.6.3 Monitoring PPPoE Client
Command name: /interface pppoe-client monitor
Property Description
ac-mac (MAC address) - MAC address of the access concentrator (AC) the client is connected to
ac-name (text) - name of the AC the client is connected to
encoding (text) - encryption and encoding (if asymmetric, separated with '/') being used in this
connection
mru (read-only: integer) - effective MRU of the link
mtu (read-only: integer) - effective MTU of the link
service-name (text) - name of the service the client is connected to
status (text) - status of the client
dialing - attempting to make a connection
verifying password... - connection has been established to the server, password verification in progress
connected - self-explanatory
terminated - interface is not enabled or the other side will not establish a connection
uptime (time) - connection time displayed in days, hours, minutes and seconds
Example
To monitor the pppoe-out1 connection:
[admin@AT-WR4562] interface pppoe-client> monitor pppoe-out1
status: "connected"
uptime: 6s
idle-time: 6s
encoding: "MPPE128 stateless"
service-name: "testSN"
ac-name: "AT-WR4562"
ac-mac: 00:0C:42:04:00:73
mtu: 1480
mru: 1480
[admin@AT-WR4562] interface pppoe-client>
8.6.4 PPPoE Server Setup (Access Concentrator)
Submenu level: /interface pppoe-server server
Description
The PPPoE server (access concentrator) supports multiple servers for each interface - with differing
service names. Currently the throughput of the PPPoE server has been tested to 160 Mb/s on a Celeron
600 CPU. Using higher speed CPUs, throughput should increase proportionately.
The access concentrator name and PPPoE service name are used by clients to identity the access
concentrator to register with. The access concentrator name is the same as the identity of the
router displayed before the command prompt. The identity may be set within the /system identity
submenu.