Filter
Top Products
32 AT-WR4500 Series - IEEE 802.11abgh Outdoor Wireless Routers
RouterOS v3 Configuration and User Guide
default - suport long cables
short - support short cables
standard - same as default
disable-running-check (yes | no; default: yes) - disable running check. If this value is set to 'no', the
router automatically detects whether the NIC is connected with a device in the network or not
full-duplex (yes | no; default: yes) - defines whether the transmission of data appears in two directions
simultaneously
mac-address (MAC address) - set the Media Access Control number of the card
mdix-enable (yes | no) - whether the MDI/X auto crosscable correction feature is enabled for the port
(if applicable)
mtu (integer; default: 1500) - Maximum Transmission Unit
name (name; default: etherN) - assigned interface name, whrere 'N' is the number of the ethernet
interface
speed (10 Mbps | 100 Mbps | 1 Gbps) - sets the data transmission speed of the interface. By default, this
value is the maximal data rate supported by the interface
When disable-running-check is set to no, the router automatically detects whether the NIC is
connected to a device in the network or not. When the remote device is not connected (the leds are not
blinking), the route which is set on the specific interface, becomes invalid.
Command Description
reset-mac (name) - set the MAC address of the NIC to the factory default setting
Example
[admin@AT-WR4562] > interface print
Flags: X - disabled, D - dynamic, R - running
# NAME TYPE RX-RATE TX-RATE MTU
0 X ether1 ether 0 0 1500
[admin@AT-WR4562] > interface enable ether1
[admin@AT-WR4562] > interface print
Flags: X - disabled, D - dynamic, R - running
# NAME TYPE RX-RATE TX-RATE MTU
0 R ether1 ether 0 0 1500
[admin@AT-WR4562] > interface ethernet
[admin@AT-WR4562] interface ethernet> print
Flags: X - disabled, R - running
# NAME MTU MAC-ADDRESS ARP
0 R ether1 1500 00:0C:42:03:00:F2 enabled
[admin@AT-WR4562] interface ethernet> print detail
Flags: X - disabled, R - running
0 R name="ether1" mtu=1500 mac-address=00:0C:42:03:00:F2 arp=enabled
disable-running-check=yes auto-negotiation=yes full-duplex=yes
cable-settings=default speed=100Mbps
[admin@AT-WR4562] interface ethernet>
4.2.3 Monitoring the Interface Status
Command name: /interface ethernet monitor
Property Description
auto-negotiation (done | incomplete) - fast link pulses (FLP) to the adjacent link station to negotiate the
SPEED and MODE of the link. Both stations choose the maximal speed boh support.
done - negotiation done
incomplete - negotiation failed
default-cable-setting (read-only: short | standard) - default cable length setting (only applicable to NS
DP83815/6 cards)
short - support short cables
standard - same as default