Filter
Top Products
AT-WR4500 Series - IEEE 802.11abgh Outdoor Wireless Routers 97
RouterOS v3 Configuration and User Guide
The necessary configuration of the RIP general settings is as follows:
[admin@AT-WR4562] routing rip> set redistribute-connected=yes
[admin@AT-WR4562] routing rip> print
distribute-default: never
redistribute-static: no
redistribute-connected: yes
redistribute-ospf: no
redistribute-bgp: no
metric-default: 1
metric-static: 1
metric-connected: 1
metric-ospf: 1
metric-bgp: 1
update-timer: 30s
timeout-timer: 3m
garbage-timer: 2m
[admin@AT-WR4562] routing rip>
The minimum required configuration of RIP interface is just enabling the network associated with the
ether1 interface:
[admin@AT-WR4562] routing rip network> add network=10.0.0.0/2
[admin@AT-WR4562] routing rip network> print
# ADDRESS
0 10.0.0.0/24
[admin@AT-WR4562] routing rip network>
There is no need to run RIP on the ether2, as no propagation of RIP information is required into the
Remote network in this example.
The routes obtained by RIP can be viewed in the /routing rip route menu:
[admin@AT-WR4562] routing rip> route print
Flags: S - static, R - rip, O - ospf, C - connect, B - bgp
0 R dst-address=0.0.0.0/0 gateway=10.0.0.26 metric=2 from=10.0.0.26
1 C dst-address=10.0.0.0/24 gateway=0.0.0.0 metric=1 from=0.0.0.0
2 C dst-address=192.168.0.0/24 gateway=0.0.0.0 metric=1 from=0.0.0.0
3 R dst-address=192.168.1.0/24 gateway=10.0.0.26 metric=1 from=10.0.0.26
4 R dst-address=192.168.3.0/24 gateway=10.0.0.26 metric=1 from=10.0.0.26
[admin@AT-WR4562] routing rip>
The regular routing table is:
[admin@AT-WR4562] routing rip> /ip route print
Flags: X - disabled, I - invalid, D - dynamic, J - rejected,
C - connect, S - static, R - rip, O - ospf, B - bgp
# DST-ADDRESS G GATEWAY DISTANCE INTERFACE
0 R 0.0.0.0/0 r 10.0.0.26 120 ether1
1 R 192.168.3.0/24 r 10.0.0.26 120 ether1
2 R 192.168.1.0/24 r 10.0.0.26 120 ether1
3 DC 192.168.0.0/24 r 0.0.0.0 0 ether2
4 DC 10.0.0.0/24 r 0.0.0.0 0 ether1
[admin@AT-WR4562] routing rip>