Filter
Top Products
10-4 DCP Mode 1 Installation and Administration
________________________________________________________________________________________________
________________________________________________________________________________________________
________________________________________________________________________________________________
Generic 2 Administration
The following Manager II translations need to be completed for a Generic 2 for static switched 56 Kbps
networking. For Generic 2 translations using dynamic 56 Kbps networking, contact the BCSDC.
NOTE
DEFINITY Manager III and Manager IV are covered in their own documentation sets. Refer
to the list of documents in Chapter 9 to find the appropriate manual for administering systems
using Manager III or Manager IV.
1. Using Procedure 100, Word 1, make the assignments shown in Fields 1 through 9. The trunk group
(76) and the dial access code/trunk ID code shown are only examples; enter the appropriate values
supplied by the BCSDC.
NOTE
To administer members of the trunk group, use Procedure 116.
If you need to change the signaling type, use Procedure 100, Word 3.
ENHANCED MODE - PROCEDURE: 100, WORD: 1
TRUNK GROUP TRANSLATION
1. Trunk Group: 76
DIAL ACCESS CODE/TRUNK ID CODE
2. Digit 1: 7
3. Digit 2: 5
4. Digit 3: 1
5. Digit 4: -
6. Trunk Type: 41
7. Dial Access Restriction: 0 Access is allowed using DAC
8. Personal CO Line Appearance: 0 Not used for CO line appearance
9. Public Network Access/Egress: 1 Enabled
DISPLAY ONLY
10. Signaling Type: 26 E&M wink/delay dial out with fail on timeout
Connected to CC0 ON-LINE ♥ MAJOR
MINOR RUN TAPE BUSY OUT IN USE WAIT
enter command: _
2 Repeat 3 Form 5 Help 6 Field 7 Input 8 Cmds
Figure 10-1. Manager II Mode 1 Administration (Proc 100, Word 1)