AT&T 585-300-903 Network Router User Manual


 
DCP Mode 2 Installation and Administration 11-27
_ ______________________________________________________________________________________
_ ______________________________________________________________________________________
_ ______________________________________________________________________________________
4. Using Procedure 014, Word 2, select the data rates that will be used by the data modules in the
modem pool. Figure 11-12, Manager II Administration for Digital Side of Modem Pooling (Proc
014, Word 2), shows data rates of 64 Kbps and 9600 bps and a custom BCCOS of 10 (these values
are shown as examples only).
NOTE
A data rate of 64 Kbps should always be translated for the modem pool in addition to
the data rates optioned on the data module; this will ensure that a modem pool is
selected when an incoming data call is directed to an AUDIX DCP port. If 64 Kbps is
not translated, the modem-pool setup may not work, or may not recover after a failure.
ENHANCED MODE - PROCEDURE: 014, WORD: 2
BEARER CAPABILITY CLASS OF SERVICE - DATA OPTIONS
1. Bearer Capability COS: 10
DATA RATE
2. 64000 bps: 1 Supported
3. 56000 bps: 0 Not supported
4. 19200 bps: 0 Not supported
5. 9600 bps: 1 Supported
6. 4800 bps: 0 Not supported
7. 2400 bps: 0 Not supported
8. 1200 bps: 0 Not supported
9. 300 bps: 0 Not supported
10. Low Speed: 0 Not supported
11. Synchronous: 0 Asynchronous
12. Duplex: 0 Full duplex
13. Clock: 0 Internal
14. Default Data Rate: 9 64000 bps
Connected to CC0 ON-LINE MAJOR
MINOR RUN TAPE BUSY OUT IN USE WAIT
enter command: _
3 Data 5 Help 6 Field 7 Input 8 Cmds
Figure 11-12. Manager II Administration for Digital Side of Modem Pooling (Proc 014, Word 2)