Filter
Top Products
10-6 DCP Mode 1 Installation and Administration
________________________________________________________________________________________________
________________________________________________________________________________________________
________________________________________________________________________________________________
3. Using Procedure 101, Word 1, make the assignments shown below:
ENHANCED MODE - PROCEDURE: 101, WORD: 1
TRUNK GROUP CHARACTERISTICS
1. Trunk Group: 76
2. Balance: 0 Disabled
3. Battery Reversal: 0 Disabled
4. Incoming Prefix Digit : -
No additional digit for DID
5. DCS: 0 Disabled
6. Touch-Tone In: 1 Enabled
7. Touch-Tone Out: 1 Enabled
8. CDR Active: 0 No
9. AIOD Billing Number: ----
TIMED RECALL
10. Time: 0
11. Level: 0 Recall occurs when recall time expires
12. CDR Variable Timer: --
Default (procedure 275 Word 3 field 12)
13. Pad Group: 0 Determined by trunk type in Procedure 100 Word 1
14. Tie Toll: 0 Not toll restircted
15. APLT Features Allowed: 0 Disabled (CCSA trunk)
16. Disconnect Supervision: 0 Disabled
Connected to CC0 ON-LINE ♥ MAJOR
MINOR RUN TAPE BUSY OUT IN USE WAIT
enter command: _
2 Repeat 3 Form 5 Help 6 Field 7 Input 8 Cmds
Figure 10-3. Manager II Mode 1 Administration (Proc 101, Word 1)