Filter
Top Products
EIA RS-232 Cabling 8-9
_ ______________________________________________________________________________________
_ ______________________________________________________________________________________
_ ______________________________________________________________________________________
Table 8-1. MPDM/M1* Option Settings
_ ________________________________
MPDM/M1* Option Settings
_ ________________________________
_ ________________________________
speed 56 Kbps or 64 Kbps
_ ________________________________
OFF-TRBK OFF
_ ________________________________
HDX-FDX OFF (FDX)
_ ________________________________
ASYN-SYNC SYNC
_ ________________________________
EXT-INT EXT
_ ________________________________
OFF-DISC OFF
_ ________________________________
OFF-KYBD OFF
_ ________________________________
OFF-PRTY OFF
_ ________________________________
O/EV-I/OD O/EV
_ ________________________________
OFF-DMLL OFF
_ ________________________________
OFF-MKBY MKBY
_ ________________________________
OFF-ANET ANET
_ ________________________________
OFF-SIGLS SIGLS
_ ________________________________
OFF-AANS AANS
_ ________________________________
SWITCH ADMINISTRATION
The only administration required at the switch is the translation of the new analog or DCP ports for
communication with the appropriate endpoints. For analog port translations, see the appropriate switch
documentation. For DCP port translations, see Chapter 9, DCP Cabling and Administration.
NOTE
Remember, if you are using MPDM/M1* data modules to convert RS-232 ports to DCP
mode 1 or DCP mode 3, these ports can only be used for incoming calls. Consequently, these
data modules must be administered as the first members of an incoming hunt group on the
switch and the DCP ports should be administered as the remaining members of the hunt
group.