Filter
Top Products
DCP Mode 1 Installation and Administration 10-5
_ ______________________________________________________________________________________
_ ______________________________________________________________________________________
_ ______________________________________________________________________________________
2. Using Procedure 100, Word 2, assign BCCOS 7 to the trunk group (trunk group 76 is only an
example).
NOTE
BCCOS 7 is the default and should not be modified. However, if BCCOS 7 has been
modified at your site, use a custom BCCOS that has the default values of BCCOS 7
(one that uses robbed-bit signaling). Refer to the DEFINITY Generic 2 Administration
Procedures manual (555-104-506) for default BCCOS values if needed.
ENHANCED MODE - PROCEDURE: 100, WORD: 2
TRUNK GROUPS - MODEM POOLING AND BCCOS
1. Trunk Group: 76
2. Bearer Capability Class of Service: 7
MODEM POOLING
3. Originate Mode: _
4. Answer Mode: _
5. Modem Type: _
6. First Choice: _
7. Test Type: _
Connected to CC0 ON-LINE ♥ MAJOR
MINOR RUN TAPE BUSY OUT IN USE WAIT
enter command: _
2 Repeat 3 Form 5 Help 6 Field 7 Input 8 Cmds
Figure 10-2. Manager II Mode 1 Administration (Proc 100, Word 2)