Filter
Top Products
Chapter 11
11-44 Command Reference Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
ip routing-mode
Command Mode Interface Configuration.
Description Sets the IP routing mode on an interface. The no form of this command
restores the default setting of RT_MGMT.
Syntax
Sample Output This example enables local packet consumption and disables IP forwarding
on an interface labeled “boston”.
(config-if:boston)# ip routing-mode MGMT_ONLY
Systems P550R, P580, P880, and P882.
To Configure: ip routing-mode {RT_MGMT | RT_ONLY |
MGMT_ONLY}
To Restore
Default:
no ip routing-mode
Table 11-22. Parameters, Keywords, Arguments
Name Definition
{RT_MGMT |
RT_ONLY |
MGMT_ONLY}
• Routing/Mgmt - IP routing is enabled on the
interface, and you can manage the switch
through the interface (from the CLI or Web
Agent).
• Mgmt Only - You can manage the switch
through the interface (from the CLI or Web
Agent), but IP routing is disabled on the
interface.
Note: Do not enable routing protocols on an
interface configured for Mgmt Only since the
interface will act as an end point and will not
pass traffic.
• Routing Only - Routing only interfaces do
not permit management traffic destined for
local interfaces but do allow all other traffic
including management traffic destined for
interfaces on other switches.