Filter
Top Products
Document No. 10-300090, Issue 1 19-25
OSPF
ip ospf router-id
Command Mode Global Configuration.
Description Sets the router-id for the system. Use the no command to restore the default
setting (the lowest IP address configured on the system).
* Note: OSPF must be disabled for this command to take effect. If
OSPF is enable on the system the change will not take effect
until OSPF is stopped and started again.
Syntax
Sample Output The following command sets the router id for interface 123 to 10.0.8.123.
(config-if:123)# ip ospf router-id 10.0.7.123
Systems P550R, P580, P880, and P882.
To Configure: ip ospf router-id <router-id>
To Restore Default: [no] ip ospf router-id
Table 19-17. Parameters, Keywords, Arguments
Name Definition
router-id IP address that represents the router-id for the system.