Filter
Top Products
Chapter 5
5-8 Command Reference Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
set console transfer ppp
Command Mode Global Configuration.
Description Transfers control of the serial console port and the CLI session to the PPP
protocol layer.
This command is accepted only when the console serial port is configured
in PPP mode.
When accepted, this command immediately terminates the current CLI
session, logs the user out, and switches the I/O on the serial console port
from the CLI processing software to the PPP layer. The remote host also
needs to simultaneously change its I/O to use PPP software. This command
is NOT stored (no back-end), and is only for use when the user has
successfully dialed-into the switch. This command can only be accepted
when the Console Serial Port is configured in PPP mode.
The command cannot be accepted from a telnet session, it can be accepted
only over directly connected serial sessions, and most preferably from a
post-dial modem terminal session on the remote host.
Syntax set console transfer ppp
Sample Output The following example sets the console transfer ppp.
(configure)# set console transfer ppp
Systems P550R, P580, P880, and P882.