Filter
Top Products
Chapter 13
13-28 Command Reference Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
ipx sap-network-filter
Command Mode Interface Configuration.
Description Specifies which services (by network) are present in SAP packets sent and
received on the interface. The no form of this command removes the filter
from an interface.
Syntax
To
Configure:
ipx sap-network-filter <precedence> <filter-network>
<service-type> {outbound | inbound | both} {filter |
allow} [<filter-hops>]
To Remove: [no] ipx sap-network-filter <precedence>
Table 13-12. Parameters, Keywords, Arguments
Name Definition
<precedence> Indicates the precedence of this SAP name filter in relation to
other SAP name filters on this interface. Lower numbers
indicate a higher precedence. The range is 0-9999.
<filter-
network>
The network of the service that this filter matches. The range
is 0 - FFFFFFFF where, FFFFFFFF matches all networks.
<service-type> The type of the IPX SAP service, in hexadecimal. The range
is 0 - FFFF where, FFFF matches all service types.
{outbound |
inbound | both}
The filter direction.
• outbound - Apply filter to SAP packets sent out the
interface.
• inbound - Apply filter to SAP packets received on the
interface.
• both - Apply filter to SAP packets in both directions.
1 of 2