Filter
Top Products
Chapter 21
21-26 Command Reference Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
set port mirror Fabric_mode2
Command Mode Global Configuration.
Description Set up or remove a port mirror on a switch in Fabric mode 2.
Syntax
To Configure: set port mirror Fabric_mode2 source-port <mod-port-
range> mirror-port <mod-port-spec> channel <channel>
direction {tx | rx | both | sa | da} sampling {always | disable
| periodic} [sa <MAC-address>] [da <MAC-address>]
[max-packets-sec <max-packets-sec-value>]
To Clear: clear port mirror Fabric_mode2 channel <channel>
Table 21-23. Parameters, Keywords, Arguments
Parameter Definition
<mod-port-
range>
Either the single port or the range of ports that you want to
mirror. See Table 21-24 for the specific port ranges that you
can mirror.
<mod-port-
spec>
The port to which you want to mirror traffic.
Both the source port and mirror port must either:
• Be on the same vlan and have the same vlan binding
or
• Have vlan binding set to bind to all
Note: Avaya recommends that you mirror traffic to a port of
the same speed or faster than the source port.
<channel> The mirror channel that you want to use. Four channels are
available. Enter a number from 1 to 4.
{tx | rx | both | sa
| da}
The direction of traffic that you want to mirror or the MAC
address filter that you want to use. If you enter sa or da, the
switch monitors both transmit and receive traffic.
Note: You can mirror transmit traffic of only one source port
to the mirror port. You cannot mirror transmit traffic
of multiple source ports to one mirror port.
1 of 2