Filter
Top Products
Configuring the NIC
Installing and Configuring the Avaya S8700-Series Server January 2008
47
Note:
Note: It is not necessary to enable the "Input to Server" ntp service. If this service is
already enabled, you do not need to disable it.
When the Avaya Installation Wizard prompts you for information about the network time
servers, enter the DNS name or the IP address for the primary network time server and the
secondary and the tertiary time servers if any. If you enter a DNS name instead of an IP address
for the network time server, you must specify the IP address of the DNS server on the DNS/
DHCP web page. For more information, see About the Avaya Installation Wizard
on page 41.
For more information about NTP, see RFC 958.
Configuring the NIC
1. From the Maintenance Web Interface, under Server Configuration, click Configure
Server.
2. Click Continue until you get to the "Specify how you want to use this Wizard" page.
3. Select Configure Individual Services and click Continue.
4. On the menu on the left, click Set Identities
5. Use the drop-down menus to assign the Ethernet port functions. Click Continue.
6. Complete the following information for Ethernet 2:
● IP address
● Gateway
● Subnet mask
● Speed