Filter
Top Products
5-11
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide
OL-4211-03
Chapter 5 Configuring the Client Adapter
Setting Advanced Parameters
Channel Specifies the channel that your client adapter uses for communications
in a 2.4-GHz ad hoc network. The available channels conform to the
IEEE 802.11 Standard for your regulatory domain.
The channel of the client adapter must be set to match the channel used
by the other clients in the wireless network. If the client adapter does
not find any other ad hoc clients, this parameter specifies the channel
with which the adapter will start its cell.
Range: Dependent on regulatory domain
Example: 1 to 11 (2412 to 2462 MHz) in North America
Default: Auto (the client automatically determines the channel on
which to start communications)
Note This parameter is available only when 2.4 GHz 11 Mbps is
selected for the Wireless Mode When Starting Ad Hoc Network
parameter. When 5 GHz 54 Mbps is selected, the Channel
parameter is set to Auto automatically.
Note Refer to Appendix D for a list of channel identifiers, channel
center frequencies, and regulatory domains for each channel.
Table 5-3 Profile Management Advanced Parameters (continued)
Parameter Description