Filter
Top Products
Removing and Replacing Parts 4-11
2. If the front bezel door is locked, press in on the right side of the lock access
panel to open the panel, exposing the keylock (see Figure 4-8). Then unlock
the bezel, remove the key, close the lock access panel, and open the bezel
door.
3. For systems with PowerEdge Expandable RAID Controllers, wait until the
drive status indicators on the drive carrier signal that the drive may be
removed safely.
If the drive has been online, the drive status indicators will flash sequen-
tially as the drive is turned off. When all indicators are turned off, the drive
is ready for removal.
4. Open the hard-disk drive carrier handle to release the carrier.
5. Slide the carrier toward you until it is free of the drive bay.
6. Remove the drive from its carrier by removing the four screws (two on
each side) that secure it in the carrier.
Before installing a new drive, set all jumpers and remove termination from the
drive. When installing the drive, align the bottom edge of the carrier with the
notches in the hard-disk drive bay and insert the carrier into the drive bay.
Close the carrier handle until it latches to ensure that the drive is fully seated in
the backplane board. Be sure to install any required SCSI drivers.
drive carrier
drive carrier handle
hard-disk drive keylock
(behind lock access panel on
front bezel)